Axis Title

[lucas erasmus]

Please make it possible to change the axis title position when there is no values indicated on the axis. The title is by default too close to the axis. This only seems to be a problem when no values are indicated on the axis. Thank you

[wilhershberger]

That is already possible using the “space for x:” settings. See the attached images. Selecting the “exactly” option gives you complete control.

I hope that this helps.

[lucas erasmus]

Thanks for the response. That works when you display values on the axis. But in my case I do not want to display values on the y-axis. Then I lose that functionality and I am stuck with a default value. See image below.

Kind Regards

Lucas

[dgteam]

The ‘Space for Y’ setting works with an axis present, but not in this case.

Instead of entering the title in the Axis settings, try a Text command with Where = ‘Y title (CCW)’ and the Anchor and Align are set to ‘Center’.

Then adjust the Offset as shown:

Does that fix your problem?

[lucas erasmus]

Thank you. This is a good work around. But can you please consider making it possible to adjust it in the conventional way in a future update.

Kind Regards

Lucas

[dgteam]

FYI – There is a modification in the latest Beta, such that if you set Space for Y to ‘Exactly’ and enter a value, the program will maintain that distance between the label and the edge of y-axis, even when you Uncheck Draw y numbers.   Then you do not need to add the additional Text command.

You can use the slider to adjust the pixels or enter a unit of measure, as shown here.